Redarc designed the Portable Solar Panel - 200 Watt - Monocrystalline # RED86VR around their BCDC and Manager30 charging systems but since this doesn't have a solar charger pre-mounted to the panels it will work just fine with any solar charger.
To connect this to the SAE connector on your Airstream you need the Adapter # GP72VR and then an Anderson extension like the 5' Long # RED27VR, 16' Long # RED99VR, or 32' Long # RED49VR cable.
Happy camping! view full answer...
For your trailer with the Solar Port Inlet for Furrion Solar Panel Battery Charger # FSPINS-BS you can use the Goal Zero Boulder 100 Briefcase Solar Panel # 287-32408, or you can use the Go Power Portable Solar Panel with Digital Solar Controller # 34282730; you'll just need to be sure to not exceed the 10 amp rating for the solar port. view full answer...
AC surge/spike suppressors vary in the level of protection they provide and in their connectivity options. Some will include a voltage regulator along with the spike suppressor. Using one along with a suitable charger is the best way to protect delicate electronic devices like computers and smartphones.
DC-source power charging is less risky since the battery power source is more stable than AC power. This device is ideal for charging phones and computers from your RV battery since it... view full answer...
Yes. Because lithium batteries have a full charge voltage of 14.4 to 14.6 volts, your standard battery charger/converter system will not be able to fully charge a lithium battery so you will need to upgrade your system. The Progressive Dynamics # PD9160ALV is compatible with lithium batteries and will work well for your single 100ah lithium battery. The # PD9160ALV is a 60amp converter and since it turns off automatically to avoid over-charging, it will help prolong the life of your new... view full answer...
If you have the Rampage Radiant Backseat Heater - 300 Watt - 12 Volt # RA3501, you will be able to power the heater by using your lithium battery. This heater will provide you with enough heat that you need for a small cargo van. The universal conversion cigarette lighter cord you need is the Rear View Safety Cigarette Lighter Adapter # RVS-505. This solution will require splicing of your battery's wires.
If you need a battery that will provide you with the power you need for your heater,... view full answer...
I'll start off by saying that whatever tow vehicle you use, if it has a 7 way connector and the trailer does too, it will provide a maintenance charge whenever it is connected. So that may provide you with a little bit of peace of mind, but it sounds like you're more concerned with keeping the battery maintained when it is not connected to a tow vehicle and is being stored.
If you're looking for a solar powered charging solution that will allow you to install and not worry about it, the... view full answer...
The 7-Way 12V power only provides a trickle charge to the tow vehicle battery. This is due to the distance between the truck battery bank and the camper battery bank. In order to charge your camper battery bank you need a "booster/maintainer" that is able to get the charge to where it needs to be to properly charge your camper battery, and for this I like to recommend the Redarc BCDC:
- 25 Amp Redarc In-Vehicle BCDC Battery Charger # 331-BCDC1225D
- Trailer Installation Kit # e79ZR
The... view full answer...
For your 2015 Jeep Grand Cherokee, you do not need a charge line kit, however it is always recommended to install one.
That being said, I recommend the Roadmaster Battery Charge Line Kit for Towed Vehicles # RM-156-25.
If there is not 12v power at the 1'oclock position on the 7-way at the rear of your RV, you also will need the Roadmaster Battery Charge Line Kit for Motorhomes # RM-156-75. view full answer...
It's always a good idea to think ahead. The Flex-a-lite Mojave Vehicle Heater # FLX640 is more of a permanent installation so if you plan on moving the heater frequently we'll want to look at something else like part # RA3501 that uses a bolt-on installation, but it's small enough that you should be able to move it around and secure it to a variety of locations.
I'm attaching a link to our selection of heaters that are normally used for camper applications. Some of them use 12V power while... view full answer...
If you're planning on flat towing your 2019 Ford F-150 then you will need a tow bar, tow bar wiring, base plates, a braking system, and safety cables. I have the following recommendations for you below:
Tow Bar: The Demco Dominator Non-Binding Tow Bar for Blue Ox Base Plates - RV Mount - 2" Hitch - 7,500lbs Item # DM9511008-BX will be a great tow bar for your 2019 Ford F-150 and has a non-binding feature that makes attaching and unhooking from the base plates on uneven ground simple and... view full answer...
Aside from the six 15A or GFCI power receptacles (5 interior and 1 exterior) and the breakers/fuses, we have all the parts you need to complete your project.
For the power inlet on the outside of your horse trailer you can use the Epicord 30 Amp Twist Lock Power Inlet # 277-000138 you previously looked at.
The Mighty Cord RV Power Cord # A10-3025ED90 is what you can use to connect your trailer to the shore power provided by the campground. This is a cord is 25 foot long which is long... view full answer...
We can absolutely help you find the parts you're looking for. For base plates that are compatible with your Blue Ox Alpha tow bar you'll want to use one of the following, depending on whether or not you've got the adaptive cruise control feature on your Traverse.
For Adaptive cruise use the Blue Ox Base Plate Kit part # BX1738
Without adaptive cruise use the Blue Ox Base Plate Kit part # BX1734
For the wiring solution I recommend using the Roadmaster # RM-15247, which will allow your... view full answer...
Go To Results